On Thu, Feb 4, 2016 at 7:33 AM, Krzysztof Adamski [off-list ref] wrote:

sunxi_pmx_set accepts pin number and then calculates offset by
subtracting pin_base from it. sunxi_pinctrl_gpio_get, on the other hand,
gets offset so we have to convert it to pin number so we won't get
negative value in sunxi_pmx_set.

This was only used on A10 so far, where there is only one GPIO chip with
pin_base set to 0 so it didn't matter. However H3 also requires this
workaround but have two pinmux sections, triggering problem for PL port.

Signed-off-by: Krzysztof Adamski <redacted>

Acked-by: Chen-Yu Tsai <redacted>

(resent as my mail setup failed to deliver)