[PATCH v3 5/5] pinctrl: sunxi: Use pin number when calling sunxi_pmx_set
From: Krzysztof Adamski <hidden>
Date: 2016-02-03 23:36:25
Also in:
linux-gpio, lkml
Subsystem:
arm/allwinner sunxi soc support, pin control subsystem, the rest · Maintainers:
Chen-Yu Tsai, Jernej Skrabec, Samuel Holland, Linus Walleij, Linus Torvalds
sunxi_pmx_set accepts pin number and then calculates offset by subtracting pin_base from it. sunxi_pinctrl_gpio_get, on the other hand, gets offset so we have to convert it to pin number so we won't get negative value in sunxi_pmx_set. This was only used on A10 so far, where there is only one GPIO chip with pin_base set to 0 so it didn't matter. However H3 also requires this workaround but have two pinmux sections, triggering problem for PL port. Signed-off-by: Krzysztof Adamski <redacted> --- drivers/pinctrl/sunxi/pinctrl-sunxi.c | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-)
diff --git a/drivers/pinctrl/sunxi/pinctrl-sunxi.c b/drivers/pinctrl/sunxi/pinctrl-sunxi.c
index 7a2465f..96f64a1 100644
--- a/drivers/pinctrl/sunxi/pinctrl-sunxi.c
+++ b/drivers/pinctrl/sunxi/pinctrl-sunxi.c@@ -459,15 +459,16 @@ static int sunxi_pinctrl_gpio_get(struct gpio_chip *chip, unsigned offset) u8 index = sunxi_data_offset(offset); u32 set_mux = pctl->desc->irq_read_needs_mux && test_bit(FLAG_USED_AS_IRQ, &chip->desc[offset].flags); + u32 pin = offset + chip->base; u32 val; if (set_mux) - sunxi_pmx_set(pctl->pctl_dev, offset, SUN4I_FUNC_INPUT); + sunxi_pmx_set(pctl->pctl_dev, pin, SUN4I_FUNC_INPUT); val = (readl(pctl->membase + reg) >> index) & DATA_PINS_MASK; if (set_mux) - sunxi_pmx_set(pctl->pctl_dev, offset, SUN4I_FUNC_IRQ); + sunxi_pmx_set(pctl->pctl_dev, pin, SUN4I_FUNC_IRQ); return !!val; }
--
2.1.4