[PATCH v2 00/11] ARM: dts: zynq: Prepare Parallella

Hi Olof and S?ren,

Am 18.10.2014 um 06:28 schrieb Olof Johansson:

On Thu, Jul 24, 2014 at 4:00 PM, Andreas F?rber [off-list ref] wrote:

quoted

Hello,

This patch series adds an initial device tree for the Parallella board.
UART, SD card, Ethernet are enabled.
Not yet enabled are HDMI, QSPI flash and 2x USB.

Andreas (Olofsson) kindly sent me a board, and I added it to the boot
farm today, it'll be included in boot reports from here on.

Good to hear.

I did a test run with yesterday's -next It looks like networking isn't
working there at the moment, clock related. Same happens with 3.17 and
latest mainline, config multi_v7_defconfig:

[WARN] [    7.943648] macb e000b000.ethernet eth0: unable to generate
target frequency: 125000000 Hz
[WARN] [   10.948681] macb e000b000.ethernet eth0: unable to generate
target frequency: 125000000 Hz

I am unable to reproduce this in my setup - at Linus' tip
c2661b806092d8ea2dccb7b02b65776555e0ee47 (v3.18-rc1-68-gc2661b8), make
oldconfig'ing my /proc/config.gz.

S?ren, in light of your explanations, should I be expecting problems
with 1GbE or with 100MbE? My board is connected to a 1GbE switch.

Regards,
Andreas

-- 
SUSE LINUX Products GmbH, Maxfeldstr. 5, 90409 N?rnberg, Germany
GF: Jeff Hawn, Jennifer Guild, Felix Imend?rffer; HRB 16746 AG N?rnberg

-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 836 bytes
Desc: OpenPGP digital signature
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20141021/1697e8d0/attachment.sig>