On Wednesday 15 January 2014 16:01:46 Russell King - ARM Linux wrote:

On Wed, Jan 15, 2014 at 02:59:59PM +0100, Arnd Bergmann wrote:

quoted

On Wednesday 15 January 2014 21:56:26 zhangfei wrote:

quoted

However, in our board cd =0 when card is deteced while cd=1 when card is
removed.
In order to mmc_gpio_get_cd return 1, MMC_CAP2_CD_ACTIVE_HIGH has to be
set, as well as new property "caps2-mmc-cd-active-low".

--- a/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt
+++ b/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt

@@ -73,6 +73,8 @@ Optional properties:
+* caps2-mmc-cd-active-low: cd pin is low when card active
+

diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c
+       if (of_find_property(np, "caps2-mmc-cd-active-low", NULL))
+               pdata->caps2 |= MMC_CAP2_CD_ACTIVE_HIGH;
+

The MMC_CAP2_CD_ACTIVE_HIGH flag should only be required for
legacy platforms. With DT parsing, you can normally specify
the polarity of the GPIO line in the GPIO specifier in DT.

Since when?

I just looked through the bindings and found that about half
of them allow passing polarity in the gpio specifier. I thought
it was more than that and IIRC the outcome of a previous discussion
was that when the gpio controller allows passing polarity, you
should use that rather than a separate flag.

Not a problem though, since we can use the cd-inverted and
wp-inverted properties.

	Arnd