On 01/15/2014 10:38 PM, Seungwon Jeon wrote:

quoted

Hmm, looks you are right.
Though not see clearly mmc_gpio_get_cd declaratoin, other drivers
directly set get_cd as mmc_gpio_get_cd.
.get_cd	= mmc_gpio_get_cd

However, in our board cd =0 when card is deteced while cd=1 when card is
removed.
In order to mmc_gpio_get_cd return 1, MMC_CAP2_CD_ACTIVE_HIGH has to be
set, as well as new property "caps2-mmc-cd-active-low".

Ok, you could do more.
mmc_gpio_get_cd() is expected to return non-zero if card is detection.

I think your board seems not to use pull-up on GPIO line for card detection.
So, MMC_CAP2_CD_ACTIVE_HIGH would be needed.

Unfortunately, the specific cd pin can not be configured.
Suspect on our board the cd =1 when card is inserted, can not measure as
no clear resister and need check with hardware guy tomorrow.

"cd-inverted" may be required as mentioned by Arnd.
Will update the patch as following if no problem.

diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c
index 9ded62c8225e..8326e54b96a8 100644
--- a/drivers/mmc/host/dw_mmc.c
+++ b/drivers/mmc/host/dw_mmc.c

@@ -1042,7 +1042,7 @@ static int dw_mci_get_cd(struct mmc_host *mmc)
        else if (brd->get_cd)
                present = !brd->get_cd(slot->id);
        else if (!IS_ERR_VALUE(gpio_cd))
-               present = !gpio_cd;
+               present = gpio_cd ^ brd->cd_inverted;
        else
                present = (mci_readl(slot->host, CDETECT) & (1 << slot->id))
                        == 0 ? 1 : 0;

@@ -2414,6 +2414,9 @@ static struct dw_mci_board *dw_mci_parse_dt(struct

dw_mci *host)
        if (of_find_property(np, "caps2-mmc-hs200-1_2v", NULL))
                pdata->caps2 |= MMC_CAP2_HS200_1_2V_SDR;

+       if (of_get_property(np, "cd-inverted", NULL))
+               pdata->cd_inverted = 1;
+
        return pdata;
 }

diff --git a/include/linux/mmc/dw_mmc.h b/include/linux/mmc/dw_mmc.h
index 6ce7d2cd3c7a..4535282589ab 100644
--- a/include/linux/mmc/dw_mmc.h
+++ b/include/linux/mmc/dw_mmc.h

@@ -238,6 +238,7 @@ struct dw_mci_board {
        u32 caps;       /* Capabilities */
        u32 caps2;      /* More capabilities */
        u32 pm_caps;    /* PM capabilities */
+       u8 cd_inverted;