On 01/14/14 13:48, Borislav Petkov wrote:

On Tue, Jan 14, 2014 at 01:30:30PM -0800, Stephen Boyd wrote:

quoted

This patchset adds support for the Krait L1/L2 cache error detection
hardware. The first patch adds the Krait l2 indirection
register code. This patch is in need of an ACK from ARM folks.
The next two patches add the driver and the binding and 
the final patch hooks it all up by adding the device tree node.

I think Boris will pick up the first and third patches since they depend
on each other. The final dts change could go through arm-soc via davidb's tree
and the Documentation patch could go through the devicetree tree. Or patches 1
through 3 can go through Boris' tree.

Changes since v4:
 * Prefixed l2 accessors functions with krait_
 * Dropped first two patches as Boris says he picked them up

Hey Stephen,

I'm going to send upstream only

[PATCH v4 1/6] edac: Don't try to cancel workqueue when it's never setup

as it is a clear bugfix.

The second one

[PATCH v4 2/6] genirq: export percpu irq functions for module usage

will have to wait for when the driver goes in. But the driver depends on
"ARM: Add Krait L2 register accessor functions" which still waits for
ACKs, right?

Ok that sounds fine. The ARM patch is fairly minor so I'm not sure if
anyone is willing to ack it, but I'm willing to wait a little while to
see if anyone will.

-- 
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
hosted by The Linux Foundation