[PATCH v3 00/10] ARM: Exynos: Add Exynos5420 SoC support
From: Tomasz Figa <hidden>
Date: 2013-06-17 11:45:58
Also in:
linux-samsung-soc, linux-serial
Hi Chander, On Monday 17 of June 2013 16:30:25 Chander Kashyap wrote:
Exynos5420 is new SoC in Samsung's Exynos5 SoC series. This series adds
initial support for this SoC.
Changes since v2:
1. Renamed oscclk to fin_pll, in order to keep it consistant with
Exynos4/Exynos5 2. Pass memory as single bank rather than splitting in
256MB size banks.
Changes since v1:
1. As not-dt platforms will not be supported from 3.11 onwards, following
patches from previous patch series are dropped:
"irqchip: exynos-combiner: set irq base as 256 for Exynos5420"
"ARM: Exynos: initialize l2x0 cache controller only for cortex-a9 based
SoCs" 2. Added device type property in cpu node in the following patch:
"ARM: dts: list the CPU nodes for Exynos5250
3. Sorted out the nodes listed in based upon the physical addresses as
suggested by Tomasz Figa.
4. As Tomasz is going to consolidate the secondary cpu power register
address calculation in all possible scnarios, hence dropped the following
patch: "ARM: Exynos: fix secondary cpu power control register address
calculation" 5. Replaced the setup/remove)_irq calls with
(request/free)_irq calls as suggested by Mark Rutland in patch:
"clocksource: exynos_mct: use (request/free)_irq calls for local timer
registration"
6. Changed the registration of epll and rpll from pll35xx to pl36xx.
7. Changed driver data selection for serial port, based on ARCH_EXYNOS.
8. Changed the interrupt cells from 2 to 1 as suggested by Tomasz Figa.
Chander Kashyap (10):
ARM: dts: fork out common Exynos5 nodes
ARM: dts: list the CPU nodes for Exynos5250
ARM: Exynos: Add support for Exynos5420 SoC
serial: samsung: select Exynos specific driver data if ARCH_EXYNOS is
defined
ARM: Exynos: use four additional chipid bits to identify Exynos
family
clk: exynos5420: register clocks using common clock framework
ARM: dts: Add initial device tree support for Exynos5420
clocksource: exynos_mct: use (request/free)_irq calls for local timer
registration
ARM: Exynos: add secondary CPU boot base location for Exynos5420
ARM: Exynos: extend soft-reset support for Exynos5420
.../devicetree/bindings/clock/exynos5420-clock.txt | 201 ++++++
arch/arm/boot/dts/Makefile | 1 +
arch/arm/boot/dts/exynos5.dtsi | 111 +++
arch/arm/boot/dts/exynos5250.dtsi | 80 +-
arch/arm/boot/dts/exynos5420-smdk5420.dts | 33 +
arch/arm/boot/dts/exynos5420.dtsi | 103 +++
arch/arm/mach-exynos/Kconfig | 10 +
arch/arm/mach-exynos/common.c | 18 +-
arch/arm/mach-exynos/include/mach/uncompress.h | 7 +-
arch/arm/mach-exynos/mach-exynos5-dt.c | 1 +
arch/arm/mach-exynos/platsmp.c | 12 +-
arch/arm/plat-samsung/include/plat/cpu.h | 8 +
drivers/clk/samsung/Makefile | 1 +
drivers/clk/samsung/clk-exynos5420.c | 762
++++++++++++++++++++ drivers/clocksource/exynos_mct.c |
35 +-
drivers/tty/serial/samsung.c | 4 +-
16 files changed, 1280 insertions(+), 107 deletions(-)
create mode 100644
Documentation/devicetree/bindings/clock/exynos5420-clock.txt create mode
100644 arch/arm/boot/dts/exynos5.dtsi
create mode 100644 arch/arm/boot/dts/exynos5420-smdk5420.dts
create mode 100644 arch/arm/boot/dts/exynos5420.dtsi
create mode 100644 drivers/clk/samsung/clk-exynos5420.cExcept one comment for patch 07/10, the whole series looks good to me. Have my Reviewed-by: Tomasz Figa <redacted> Best regards, Tomasz