[PATCH 3/5] net/at91_ether: move eth addr quirk into csb337 board setup

On Sun, Oct 21, 2012 at 8:34 PM, Jean-Christophe PLAGNIOL-VILLARD
[off-list ref] wrote:

On 16:23 Sun 21 Oct     , Joachim Eastwood wrote:

quoted

Move Ethernet address byte order fix for csb337 into it's board
setup.

This will allow us to remove the last mach include from at91_ether
and also to share the address setup with the macb driver.

no the current drivers expect mach/board.h, mach/at91rm9200_emac.h, asm/gpio.h

waht you did will not even compile on non at91 platform

Did you even compile it on non at91?

This is the last mach include in the at91_ether driver in net-next.
And, yes, after this patch it complies fine for at least x86_64.

regards
Joachim Eastwood