[PATCH V2] ARM: dt: tegra: paz00: add regulators

On Wednesday 27 June 2012 12:56:01 Stephen Warren wrote:

On 06/27/2012 12:50 PM, Marc Dietrich wrote:

quoted

On Wednesday 27 June 2012 12:31:01 Mark Brown wrote:

quoted

On Tue, Jun 26, 2012 at 06:31:00PM -0600, Stephen Warren wrote:

quoted

sm1: HW defaults and schematic match at 1.0v. marvin24's kernel had a
max
of 1.125v, but this wasn't applied since apply_uV wasn't set.

apply_uV is only valid if a single voltage is specified.

yes, that's why there is a ".apply_uV = (_minmv == _maxmv)" in the
regulator macro.

quoted

If a voltage
range were specified and it were acted on we'd take the lowest (not
highest) voltage allowed.

Sorry, I don't get it. In this case, the board wouldn't boot at all
because
nearly all supplies would be undervoltaged. I just checked and all
voltages
are actually set to the *highest* (max) value. Maybe they aren't changed
at
all?

Yes, in the absence of any explicit action (i.e. a call to
regulator_set_voltage() elsewhere), the regulator core doesn't reprogram
the regulator at registration time, except for a few specific conditions
e.g. something like when min==max and apply_uV is set.

I imagine the DVFS code in your downstream kernel /is/ calling
regulator_set_voltage() later, assuming that config option is enabled
anyway. See arch/arm/mach-tegra/{dvfs.c,tegra2_dvfs.c}.

Great, so all the tables (except sm0/1) were moot :-( At least I learned 
something again ;-)

Stephen, I'm going to test your patch, just a few minutes ...

Thanks

Marc