[PATCH V2] ARM: dt: tegra: paz00: add regulators

On Wednesday 27 June 2012 12:31:01 Mark Brown wrote:

On Tue, Jun 26, 2012 at 06:31:00PM -0600, Stephen Warren wrote:

quoted

sm1: HW defaults and schematic match at 1.0v. marvin24's kernel had a max
of 1.125v, but this wasn't applied since apply_uV wasn't set.

apply_uV is only valid if a single voltage is specified.  

yes, that's why there is a ".apply_uV = (_minmv == _maxmv)" in the regulator 
macro.

If a voltage
range were specified and it were acted on we'd take the lowest (not
highest) voltage allowed.

Sorry, I don't get it. In this case, the board wouldn't boot at all because 
nearly all supplies would be undervoltaged. I just checked and all voltages 
are actually set to the *highest* (max) value. Maybe they aren't changed at 
all?

Marc