30/03/2018 17:40, Thomas Monjalon:

I know that this patch is already applied,
but I have some comments below.
Please try to address them.

21/03/2018 15:27, Remy Horton:

quoted

+	/* If number of queues specified by application for both Rx and Tx is
+	 * zero, use driver preferred values. This cannot be done individually
+	 * as it is valid for either Tx or Rx (but not both) to be zero.
+	 * If driver does not provide any preferred valued, fall back on
+	 * EAL defaults.
+	 */

The fallback could be set in rte_eth_dev_info_get() and call this function
instead of calling directly dev_ops->dev_infos_get.
It would require to never return -ENOTSUP.

At least, some default values should be set in rte_eth_dev_info_get().

I see it has been discussed in v1.
And it was decided to not have ethdev defaults in rte_eth_dev_info_get.

quoted

@@ -1029,6 +1048,10 @@ struct rte_eth_dev_info {
 	/** Configured number of rx/tx queues */
 	uint16_t nb_rx_queues; /**< Number of RX queues. */
 	uint16_t nb_tx_queues; /**< Number of TX queues. */
+
+	/** Tx/Rx parameter recommendations */
+	struct rte_eth_dev_portconf default_rxportconf;
+	struct rte_eth_dev_portconf default_txportconf;

Some formatting comments:
Usually, there is no blank line in structs.
The doxygen comment must apply to each field.
Have you checked what is the doxygen output?