Hi Andrew,
Thank you for your reply.
quoted
On the AST2600 platform, the RGMII delay is controlled via the SCU
registers. The delay chain configuration differs between MAC0/1 and
MAC2/3, even though all four MACs use a 32-stage delay chain.
+------+----------+-----------+-------------+-------------+
| |Delay Unit|Delay Stage|TX Edge Stage|RX Edge Stage|
+------+----------+-----------+-------------+-------------+
|MAC0/1| 45 ps| 32 | 0 | 0 |
+------+----------+-----------+-------------+-------------+
|MAC2/3| 250 ps| 32 | 0 | 26 |
+------+----------+-----------+-------------+-------------+
For MAC2/3, the "no delay" condition starts from stage 26.
Setting the RX delay stage to 26 means that no additional RX delay is
applied.
Here lists the RX delay setting of MAC2/3 below.
26 -> 0 ns, 27 -> 0.25 ns, ... , 31 -> 1.25 ns,
0 -> 1.5 ns, 1 -> 1.75 ns, ... , 25 -> 7.75 ns
Therefore, we calculate the delay stage from the rx-internal-delay-ps
of MAC2/3 to add 26. If the stage is equel to or bigger than 32, the
delay stage will be mask 0x1f to get the correct setting.
Please return -EINVAL. Asking for more than 7.75ns is clearly broken.
...
tx_delay_index = DIV_ROUND_CLOSEST(rgmii_tx_delay, rgmii_delay_unit);
if (tx_delay_index >= 32) {
dev_err(dev, "The %u ps of TX delay is out of range\n",
rgmii_tx_delay);
return -EINVAL;
}
rx_delay_index = DIV_ROUND_CLOSEST(rgmii_rx_delay, rgmii_delay_unit);
if (rx_delay_index >= 32) {
dev_err(dev, "The %u ps of RX delay is out of range\n",
rgmii_rx_delay);
return -EINVAL;
}
...
These codes will calculate the ns delay to MAC delay index.
(rgmii_delay_unit is 250 ps on MAC2/3)
If set tx delay to 8 ns on MAC2 or MAC3, it will get index is 32.
It is over the delay configuration range, here will return -EINVAL.
Thanks,
Jacky