Re: [PATCH net-next 2/8] dt-bindings: net: lan9645x: add LAN9645X switch bindings
flat view
From: Andrew Lunn <andrew@lunn.ch>
Date: 2026-03-03 14:18:54
Also in:
linux-devicetree, lkml
quoted hunk ↗ jump to hunk
+ properties: + microchip,led-drive-mode: + $ref: /schemas/types.yaml#/definitions/uint32 + description: | + Set the LED drive mode for the copper PHY associated with + this port. + + 0 - LED1 and LED2 in open-drain mode + 1 - LED1 in active drive mode (can be used for single-LED + configurations requiring active drive) + 2 - Reserved + 3 - LED1 and LED2 in active drive mode + minimum: 0 + maximum: 3
I doubt the DT Maintainers will accept that. This looks a lot like a
value you write into a register. How are active drive and open-drain
described in other DT bindings? Is there something you can reuse?
For 1, what happens to LED2? Not used at all?
Andrew