[PATCH net-next 1/2] dt-bindings: net: sff,sfp: Describe power supply pins
From: Romain Gantois <romain.gantois@bootlin.com>
Date: 2026-03-03 13:54:38
Also in:
linux-devicetree, lkml
Subsystem:
networking drivers, open firmware and flattened device tree bindings, sff/sfp/sfp+ module support, the rest · Maintainers:
Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Russell King, Linus Torvalds
SFP cages and soldered-on SFF transceivers have two separate power supply pins: one for the transmitter circuit, and one for the receiver circuit. Describe these two pins and the regulators supplying them. Signed-off-by: Romain Gantois <romain.gantois@bootlin.com> --- Documentation/devicetree/bindings/net/sff,sfp.yaml | 8 ++++++++ 1 file changed, 8 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/sff,sfp.yaml b/Documentation/devicetree/bindings/net/sff,sfp.yaml
index 15616ad737f57..95729cf694a7d 100644
--- a/Documentation/devicetree/bindings/net/sff,sfp.yaml
+++ b/Documentation/devicetree/bindings/net/sff,sfp.yaml@@ -68,6 +68,14 @@ properties: output gpio signal (SFP+ only), low - low Tx rate, high - high Tx rate. Must not be present for SFF modules + vccr-supply: + description: + Phandle to a regulator supplying the receiver power (AKA VccR) pin. + + vcct-supply: + description: + Phandle to a regulator supplying the transmitter power (AKA VccT) pin. + allOf: - if: properties:
--
2.52.0