On Sun, Feb 18, 2024 at 09:27:22PM +0100, Christian Marangi wrote:
On Sun, Feb 18, 2024 at 09:10:30PM +0100, Andrew Lunn wrote:
quoted
quoted
quoted
quoted
+ phy_dev_id = (struct mdio_device_id *)&phydev->dev_id;
Why this cast? Try to write code that doesn't need casts.
This cast is needed to keep the dev_id const in the phy_device struct so
that other are warned to not modify it and should only be handled by
phy_probe since it's the one that fills it.
Alternative is to drop const and drop the warning.
Can you propagate the const. Make phy_dev_id point to a const?
Mhh not following, I tried changing to const struct mdio_device_id *phy_dev_id
but that results in memcpy complain (dest is void * not const) and
writing in read-only for the single PHY part (the else part)
An alternative might be to make dev_id a pointer in struct phy_device
and dynamically allocate a mdio_device_id for the case of single PHY
(else case). That effectively remove the need of this cast but I would
love to skip checking for -ENOMEM (this is why i made that local)
If it's OK to dynamically allocate for the else case then I will make
this change. I just tested this implementation and works correctly with
not warning.
Why do we need memcpy() etc - as I demonstrated in my proposal, it's
not necessary if we introduce a mdio_device_id within struct phy_driver
and we can just store a const pointer to the mdio_device_id that
matched. That was very much an intentional decision in my proposal to
make the code simple.
--
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 80Mbps down 10Mbps up. Decent connectivity at last!