Am Thu, Dec 21, 2023 at 03:25:56PM +0100 schrieb Andrew Lunn:

quoted

Without setting the master-slave option it didn't work. I think its
mandatory.

I don't think it is. The PHY should have a default setting for
master-slave. Often its based on the typical use case. If its
typically inside a switch, then it should default to prefer-master. If
its typically in an end system, then it should be prefer-slave.

That would be the case if you use a forced configuration. I think this
is already implemented by reading out the MDIO_PMA_PMD_BT1_CTRL in        
genphy_c45_pma_baset1_read_master_slave. Probably the problem arises    
with following lines which prevents an inital read of the configuration:

static int mv88q2xxx_config_init(struct phy_device *phydev)
{
        int ret;
                                                                        
        /* The 88Q2XXX PHYs do have the extended ability register available, but
         * register MDIO_PMA_EXTABLE where they should signalize it does not
         * work according to specification. Therefore, we force it here.
         */
        phydev->pma_extable = MDIO_PMA_EXTABLE_BT1;

        if (phydev->drv->phy_id == MARVELL_PHY_ID_88Q2220)
                return 0;

        /* Read the current PHY configuration */
        ret = genphy_c45_read_pma(phydev);
        if (ret)
                return ret;

        return mv88q2xxx_config_aneg(phydev);
}

If I type in "ethtool -s eth0 autoneg on" I don't have to set the 
master-slave option. Is the assumption here that we always start with a 
forced configuration ? If yes, then I have to fix it.

    Andrew

	Dimitri