Re: [PATCH net-next v6] net: phy: intel-xway: Add RGMII internal delay configuration

Hi Martin,

Am 2023-02-24 07:25, schrieb Martin Schiller:

On 2023-02-22 17:04, Michael Walle wrote:

quoted

Hi Tim, Hi Martin,

quoted

I've got some boards with the GPY111 phy on them and I'm finding that
modifying XWAY_MDIO_MIICTRL to change the skew has no effect unless I
do a soft reset (BCMR_RESET) first. I don't see anything in the
datasheet which specifies this to be the case so I'm interested it
what you have found. Are you sure adjusting the skews like this
without a soft (or hard pin based) reset actually works?

I do have the same PHY and I'm puzzled with the delay settings. Do
you have an EEPROM attached to the PHY? According to my datasheet,
that seems to make a difference. Apparently, only if there is an
EEPROM, you can change the value (the value is then also written to
the EEPROM according the datasheet).
If you don't have one, the values will get overwritten by the
external strappings on a soft reset. Therefore, it seems they cannot
be set. (FWIW there is also a sticky bit, but that doesn't seem to
help in this case).

-michael

Yes, you are right. The datasheet says: "In no-EEPROM mode, writing to
this register has no impact on operation of the device".

But changing this settings without an EEPROM indeed has an impact.

We don't use an EEPROM and without tuning this values some boards are
unable to communicate on the ethernet port(s).

Thanks for confirming! Could you share your PHYID1/PHYID2 register and
firmware version (FWV, 0x1E) contents?

In our case, any changes in MIICTRL are lost after a soft reset.

I varied these values during operation in the uboot and was able to 
test
the limits very nicely.

So I guess, the value you write into MIICTRL are retained on a soft 
reset.
I.e.

mii write <phyad> 0x17 0xffff
mii write <phyad> 0x00 0x8000
mii read <phyad> 0x17

will still return 0xffff?

I wouldn't have introduced this feature if it hasn't got any impact.

Sure, I'm just trying to figure out the differences ;)

Thanks,
Michael