Re: [PATCH net-next v1 2/7] dt-bindings: net: phy: add PoDL PSE property

On Mon, Aug 22, 2022 at 01:45:34PM -0500, Rob Herring wrote:

On Fri, Aug 19, 2022 at 02:01:04PM +0200, Oleksij Rempel wrote:

quoted

Add property to reference node representing a PoDL Power Sourcing Equipment.

Signed-off-by: Oleksij Rempel <o.rempel@pengutronix.de>
---
 Documentation/devicetree/bindings/net/ethernet-phy.yaml | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/Documentation/devicetree/bindings/net/ethernet-phy.yaml b/Documentation/devicetree/bindings/net/ethernet-phy.yaml
index ed1415a4381f2..49c74e177c788 100644
--- a/Documentation/devicetree/bindings/net/ethernet-phy.yaml
+++ b/Documentation/devicetree/bindings/net/ethernet-phy.yaml

@@ -144,6 +144,12 @@ properties:
       Mark the corresponding energy efficient ethernet mode as
       broken and request the ethernet to stop advertising it.
 
+  ieee802.3-podl-pse:
+    $ref: /schemas/types.yaml#/definitions/phandle
+    description:
+      Specifies a reference to a node representing a Power over Data Lines
+      Power Sourcing Equipment.

Ah, here is the consumer.

Why do you anything more than just a -supply property here for the 
PoE/PoDL supply? The only reason I see is you happen to want a separate 
driver for this and a separate node happens to be a convenient way to 
instantiate drivers in Linux. Convince me otherwise.

The regulator binding provides a lot of very useful properties, which
look to do a good job describing the regulator part of a PoE/PeDL
supplier side. What however is missing is the communication part, the
power provider and the power consumer communicate with each other, via
a serial protocol. They negotiate the supply of power, a sleep mode
where power is reduced, but not removed, etc.

So a Power Sourcing Equipment driver is very likely to have a
regulator embedded in it, but its more than a regulator.

	 Andrew