On Fri, May 27, 2022 at 6:56 PM Michael S. Tsirkin [off-list ref] wrote:

On Thu, May 26, 2022 at 12:54:32PM +0000, Parav Pandit wrote:

quoted

quoted

From: Eugenio Pérez <eperezma@redhat.com>
Sent: Thursday, May 26, 2022 8:44 AM

quoted

Implement stop operation for vdpa_sim devices, so vhost-vdpa will offer

that backend feature and userspace can effectively stop the device.



This is a must before get virtqueue indexes (base) for live migration,

since the device could modify them after userland gets them. There are

individual ways to perform that action for some devices

(VHOST_NET_SET_BACKEND, VHOST_VSOCK_SET_RUNNING, ...) but there
was no

way to perform it for any vhost device (and, in particular, vhost-vdpa).



After the return of ioctl with stop != 0, the device MUST finish any

pending operations like in flight requests. It must also preserve all

the necessary state (the virtqueue vring base plus the possible device

specific states) that is required for restoring in the future. The

device must not change its configuration after that point.



After the return of ioctl with stop == 0, the device can continue

processing buffers as long as typical conditions are met (vq is enabled,

DRIVER_OK status bit is enabled, etc).

Just to be clear, we are adding vdpa level new ioctl() that doesn’t map to any mechanism in the virtio spec.

Why can't we use this ioctl() to indicate driver to start/stop the device instead of driving it through the driver_ok?
This is in the context of other discussion we had in the LM series.

If there's something in the spec that does this then let's use that.

Actually, we try to propose a independent feature here:

https://lists.oasis-open.org/archives/virtio-dev/202111/msg00020.html

Does it make sense to you?

Thanks

Unfortunately the LM series seems to be stuck on moving
bits around with the admin virtqueue ...

--
MST