[net-next PATCH v3 08/13] dt-bindings: net: dsa: qca8k: Document qca,sgmii-enable-pll
From: Ansuel Smith <ansuelsmth@gmail.com>
Date: 2021-10-10 01:56:55
Also in:
linux-devicetree, lkml
Subsystem:
networking drivers, networking [dsa], open firmware and flattened device tree bindings, the rest · Maintainers:
Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Andrew Lunn, Vladimir Oltean, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
Document qca,sgmii-enable-pll binding used in the CPU nodes to enable SGMII PLL on MAC config. Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com> --- Documentation/devicetree/bindings/net/dsa/qca8k.txt | 10 ++++++++++ 1 file changed, 10 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/dsa/qca8k.txt b/Documentation/devicetree/bindings/net/dsa/qca8k.txt
index aeb206556f54..05a8ddfb5483 100644
--- a/Documentation/devicetree/bindings/net/dsa/qca8k.txt
+++ b/Documentation/devicetree/bindings/net/dsa/qca8k.txt@@ -45,6 +45,16 @@ A CPU port node has the following optional node: Mostly used in qca8327 with CPU port 0 set to sgmii. - qca,sgmii-txclk-falling-edge: Set the transmit clock phase to falling edge. +- qca,sgmii-enable-pll : For SGMII CPU port, explicitly enable PLL, TX and RX + chain along with Signal Detection. + This should NOT be enabled for qca8327. If enabled with + qca8327 the sgmii port won't correctly init and an err + is printed. + This can be required for qca8337 switch with revision 2. + A warning is displayed when used with revision greater + 2. + With CPU port set to sgmii and qca8337 it is advised + to set this unless a communication problem is observed. For QCA8K the 'fixed-link' sub-node supports only the following properties:
--
2.32.0