Re: [RFC PATCH net-next v2 1/6] ethtool: Add ability to control transceiver modules' power mode

On Wed, Aug 18, 2021 at 03:32:41PM -0700, Jakub Kicinski wrote:

On Wed, 18 Aug 2021 18:51:57 +0300 Ido Schimmel wrote:

quoted

+MODULE_SET
+==========
+
+Sets transceiver module parameters.
+
+Request contents:
+
+  ======================================  ======  ==========================
+  ``ETHTOOL_A_MODULE_HEADER``             nested  request header
+  ``ETHTOOL_A_MODULE_POWER_MODE_POLICY``  u8      power mode policy
+  ======================================  ======  ==========================
+
+When set, the optional ``ETHTOOL_A_MODULE_POWER_MODE_POLICY`` attribute is used
+to set the transceiver module power policy enforced by the host. Possible
+values are:
+
+.. kernel-doc:: include/uapi/linux/ethtool.h
+    :identifiers: ethtool_module_power_mode_policy
+
+For SFF-8636 modules, low power mode is forced by the host according to table
+6-10 in revision 2.10a of the specification.
+
+For CMIS modules, low power mode is forced by the host according to table 6-12
+in revision 5.0 of the specification.
+
+To avoid changes to the operational state of the device, power mode policy can
+only be set when the device is administratively down.

Would you mind explaining why?

Yes, it is more restrictive than it should be. The check can be relaxed
to only disallow transition to low power mode when the device is
administratively up.

quoted

+/**
+ * enum ethtool_module_power_mode_policy - plug-in module power mode policy
+ * @ETHTOOL_MODULE_POWER_MODE_POLICY_LOW: Module is always in low power mode.

Did you have a use case for this one or is it for completeness? Seems
like user can just bring the port down if they want no carrier? My
understanding was you primarily wanted the latter two, and those can
be freely changed when netdev is running, right?

In all the implementations I could find (3), the user interface is
high/low (on/off). The proposed interface is more flexible as it
contains both the 'high' / 'low' policies in addition to the more user
friendly 'high-on-up' ('auto') policy.

Given that keeping the 'low' policy does not complicate the
implementation / maintenance and that it provides users with a similar
interface to what they are used to from other implementations, I would
like to keep it in addition to the other two policies.

quoted

+ * @ETHTOOL_MODULE_POWER_MODE_POLICY_HIGH: Module is always in high power mode.
+ * @ETHTOOL_MODULE_POWER_MODE_POLICY_HIGH_ON_UP: Module is transitioned by the
+ *	host to high power mode when the first port using it is put
+ *	administratively up and to low power mode when the last port using it
+ *	is put administratively down.

s/HIGH_ON_UP/AUTO/ ?

OK

high on up == low on down, right, seems arbitrary to pick one over the
other