Hi Marc,

On 14/04/21 9:03 pm, Marc Kleine-Budde wrote:

On 14.04.2021 19:35:18, Aswath Govindraju wrote:

quoted

Add binding documentation for TI TCAN104x CAN transceivers.

Signed-off-by: Aswath Govindraju <redacted>
---
 .../bindings/phy/ti,tcan104x-can.yaml         | 56 +++++++++++++++++++
 MAINTAINERS                                   |  1 +
 2 files changed, 57 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml

diff --git a/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
new file mode 100644
index 000000000000..4abfc30a97d0
--- /dev/null
+++ b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml

@@ -0,0 +1,56 @@
+# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
+%YAML 1.2
+---
+$id: "http://devicetree.org/schemas/phy/ti,tcan104x-can.yaml#"
+$schema: "http://devicetree.org/meta-schemas/core.yaml#"
+
+title: TCAN104x CAN TRANSCEIVER PHY
+
+maintainers:
+  - Aswath Govindraju <a-govindraju@ti.com>
+
+properties:
+  $nodename:
+    pattern: "^tcan104x-phy"
+
+  compatible:
+    enum:
+      - ti,tcan1042
+      - ti,tcan1043

Can you ensure that the 1042 has only the standby gpio and the 1043 has both?

In the driver, it is the way the flags have been set for ti,tcan1042 and
ti,tcan1043.

quoted

+
+  '#phy-cells':
+    const: 0
+
+  standby-gpios:
+    description:
+      gpio node to toggle standby signal on transceiver
+    maxItems: 1
+
+  enable-gpios:
+    description:
+      gpio node to toggle enable signal on transceiver
+    maxItems: 1
+
+  max-bitrate:
+    $ref: /schemas/types.yaml#/definitions/uint32
+    description:
+      max bit rate supported in bps
+    minimum: 1
+
+required:
+  - compatible
+  - '#phy-cells'
+
+additionalProperties: false
+
+examples:
+  - |
+    #include <dt-bindings/gpio/gpio.h>
+
+    transceiver1: tcan104x-phy {
+      compatible = "ti,tcan1043";
+      #phy-cells = <0>;
+      max-bitrate = <5000000>;
+      standby-gpios = <&wakeup_gpio1 16 GPIO_ACTIVE_LOW>;
+      enable-gpios = <&main_gpio1 67 GPIO_ACTIVE_LOW>;

AFAICS the enable gpio is active high.

I will correct this in the respin.

Thanks,
Aswath

Marc