[PATCH net 4/4] net: bcmgenet: reset 40nm EPHY on energy detect
From: Doug Berger <opendmb@gmail.com>
Date: 2019-10-16 23:07:40
Also in:
lkml
Subsystem:
broadcom genet ethernet driver, networking drivers, the rest · Maintainers:
Doug Berger, Florian Fainelli, Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Linus Torvalds
The EPHY integrated into the 40nm Set-Top Box devices can falsely
detect energy when connected to a disabled peer interface. When the
peer interface is enabled the EPHY will detect and report the link
as active, but on occasion may get into a state where it is not
able to exchange data with the connected GENET MAC. This issue has
not been observed when the link parameters are auto-negotiated;
however, it has been observed with a manually configured link.
It has been empirically determined that issuing a soft reset to the
EPHY when energy is detected prevents it from getting into this bad
state.
Fixes: 1c1008c793fa ("net: bcmgenet: add main driver file")
Signed-off-by: Doug Berger <opendmb@gmail.com>
---
drivers/net/ethernet/broadcom/genet/bcmgenet.c | 9 ++++++++-
1 file changed, 8 insertions(+), 1 deletion(-)
diff --git a/drivers/net/ethernet/broadcom/genet/bcmgenet.c b/drivers/net/ethernet/broadcom/genet/bcmgenet.c
index f0937c650e3c..0f138280315a 100644
--- a/drivers/net/ethernet/broadcom/genet/bcmgenet.c
+++ b/drivers/net/ethernet/broadcom/genet/bcmgenet.c@@ -2018,6 +2018,8 @@ static void bcmgenet_link_intr_enable(struct bcmgenet_priv *priv) */ if (priv->internal_phy) { int0_enable |= UMAC_IRQ_LINK_EVENT; + if (GENET_IS_V1(priv) || GENET_IS_V2(priv) || GENET_IS_V3(priv)) + int0_enable |= UMAC_IRQ_PHY_DET_R; } else if (priv->ext_phy) { int0_enable |= UMAC_IRQ_LINK_EVENT; } else if (priv->phy_interface == PHY_INTERFACE_MODE_MOCA) {
@@ -2611,9 +2613,14 @@ static void bcmgenet_irq_task(struct work_struct *work) priv->irq0_stat = 0; spin_unlock_irq(&priv->lock); + if (status & UMAC_IRQ_PHY_DET_R && + priv->dev->phydev->autoneg != AUTONEG_ENABLE) + phy_init_hw(priv->dev->phydev); + /* Link UP/DOWN event */ if (status & UMAC_IRQ_LINK_EVENT) phy_mac_interrupt(priv->dev->phydev); + } /* bcmgenet_isr1: handle Rx and Tx priority queues */
@@ -2708,7 +2715,7 @@ static irqreturn_t bcmgenet_isr0(int irq, void *dev_id) } /* all other interested interrupts handled in bottom half */ - status &= UMAC_IRQ_LINK_EVENT; + status &= (UMAC_IRQ_LINK_EVENT | UMAC_IRQ_PHY_DET_R); if (status) { /* Save irq status for bottom-half processing. */ spin_lock_irqsave(&priv->lock, flags);
--
2.7.4