On 02/27/2016 07:19 PM, Peter Hurley wrote:

Hi Eric,

Hi Peter,

Because both the uart driver (omap8250) and the dmaengine driver
(edma) were (relatively) new, we assumed there was some race between
starting a new rx DMA and processing the previous one.

Now after digesting the whole thread. I complained about this a long
while ago. After you start RX-DMA the DMA-engine is not programmed
immediately but deferred into softirq/tasklet. This is not the case for
continuous DMA transfer - those are programmed right away.

I don't remember that I found a reason why this simple programming has
to be deferred and can't happen immediately like it is the case for the
continuous DMA transfers. So I skipped that. RX-DMA in UART was working
well but for some reason omap's MMC-card driver refused to work.

Sebastian