Thread (51 messages) 51 messages, 11 authors, 2015-03-30

Re: [PATCH net-next RFC v2] switchdev: bridge: drop hardware forwarded packets

From: roopa <hidden>
Date: 2015-03-23 14:00:52

On 3/22/15, 5:22 PM, Guenter Roeck wrote:
On Fri, Mar 20, 2015 at 11:09:46PM +0100, Andrew Lunn wrote:
quoted
quoted
since we have discussed this problem multiple times in switchdev meetings,
the intent of this RFC is to see get the code out and also see if
rocker or any other in-kernel
driver can use it.
The Marvell switches in DSA don't have any way to mark packets why
they where forwarded towards the host. So i don't see how we could use
this feature with these chips.
If we (re-)enable unknown address flooding in the Marvell switch chips,
we could simply mark all packets received from the switch as "forwarded
by hardware". Sure, there is no bit in the header, but we would know
from the chip configuration that the packets were forwarded.

There may be a different problem, though: The driver won't know if
the packet still needs to be forwarded by the soft bridge, for
example to a port of a switch on another network interface
which is part of the same bridge group.

		+---+
		|br0|
		+---+
		 | |
	+--------+ +----+
	|		|
       +---+	      +---+
       |sw0|	      |sw1|
       +---+	      +---+
        | +---+	        |
      +--+  +--+       +--+
      |p0|  |p1|	      |p2|
      +--+  +--+	      +--+

In this scenarion, sw0 can only know that it forwarded a packet to ports
on the same switch. It does not know know that the packet needs to be
forwarded to p2 as well. It would forward the packet from p0 to p1, and
thus presumably set the hw_fwded bit, but br0 still needs to forward it.

Maybe the check should be "if the packet was HW forwarded, the destination
is a switch, and the destination is the same switch, don't forward the packet".
correct. And that's why my patch had the check in the bridge driver and
the check included  check for 'hw forwarded' flag in the packet and also 
checked that the port being forwarded to was
a switch port (port has NETIF_F_HW_SWITCH_OFFLOAD). I don't have the 
'same switch' check yet
for simplicity.
This would be expensive, but on the other side it should not affect too
many packets.
agreed.
Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help