Re: [PATCH RFC 2/2] net: dsa: bcm_sf2: implement HW bridging operations
flat view
From: Guenter Roeck <linux@roeck-us.net>
Date: 2015-02-20 04:06:09
On Thu, Feb 19, 2015 at 06:41:34PM -0800, roopa wrote:
On 2/19/15, 6:00 PM, Florian Fainelli wrote:quoted
On 19/02/15 17:46, roopa wrote:quoted
On 2/19/15, 5:03 PM, Guenter Roeck wrote:quoted
On Thu, Feb 19, 2015 at 04:51:30PM -0800, roopa wrote:quoted
quoted
Not sure yet what to do about setting the fdb aging time. I don't see a mechanism to do that. No idea how important that is.rocker, the only consumer today relies on the bridge driver aging of learnt entries. You could do the same.Remember that we are dealing with hardware switch chips. Those chips won't time out fdb entries just because the kernel's bridge driver thinks that it should.Oh, they dont..?. sorry, I dont know the details about your hardware. But, if these are entries learnt by hw, there should be a hw config to age them (I guess that is what you are talking about). Which the swicth driver can set. If you disable hw aging, you can sync these entries to the bridge driver, and make the bridge driver age them followed by a subsequent delete in hw.The SF2 HW has and aging and a valid bit available, I guess my question would be, do we have anything today in "net-next" that allows configuring HW aging vs. SW aging (implying doing a HW to SW sync)?There is no config parameter to set HW aging vs SW aging. But if you want SW aging, an example is the rocker implementation today. And there is BR_LEARNING_SYNC per bridge port flag to sync HW to SW using notifiers (see rocker).
SW aging is not practical. In my specific use case there can be 800+ mac addresses in a single mac domain, connected through an mdio bus on gpio pins. Besides, it doesn't really make much sense to burden SW with something that can easily be handled in HW, just because SW doesn't have the means to pass the necessary parameter - aging time - to the HW. I think the question here was how to communicate aging time to the switch chip, not SW aging vs. HW aging.
There is no netlink based age time sets AFAIK. But there is age time sets from sysctl. And there is no offload support for this today. The offload support has been discussed previously and there was no need to add it immediately.
Ok with me; just hope it doesn't cause any trouble. Guenter