From: Lothar Waßmann

David Laight wrote:

quoted

From: Lothar Waßmann

quoted

commit 1b7bde6d659d ("net: fec: implement rx_copybreak to improve rx performance")
introduced a regression for i.MX28. The swap_buffer() function doing
the endian conversion of the received data on i.MX28 may access memory
beyond the actual packet size in the DMA buffer. fec_enet_copybreak()
does not copy those bytes, so that the last bytes of a packet may be
filled with invalid data after swapping.
This will likely lead to checksum errors on received packets.
E.g. when trying to mount an NFS rootfs:
UDP: bad checksum. From 192.168.1.225:111 to 192.168.100.73:44662 ulen 36

Do the byte swapping and copying to the new skb in one go if
necessary.

Signed-off-by: Lothar Wamann <redacted>
---
 drivers/net/ethernet/freescale/fec_main.c |   25 +++++++++++++++++++++----
 1 file changed, 21 insertions(+), 4 deletions(-)

@@ -1455,7 +1472,7 @@ fec_enet_rx_queue(struct net_device *ndev, int budget, u16 queue_id)
 		prefetch(skb->data - NET_IP_ALIGN);
 		skb_put(skb, pkt_len - 4);
 		data = skb->data;
-		if (fep->quirks & FEC_QUIRK_SWAP_FRAME)
+		if (!is_copybreak && need_swap)
 			swap_buffer(data, pkt_len);

It has to be better to set the 'copybreak' limit to be larger than the
maximum frame size and so always go through the 'copybreak' paths.

Since the copybreak support is all about performance optimistation, we
should IMO buy the additional advantage for i.MX28 by not having to
access the buffer twice (once for copying and once again for swapping).

You definitely want to do the byteswap at the same time as the copy.

The point I'm trying to make that if you need to do the byteswap you
probably might as well copy the data to an skb of the correct size at
the same time.
Certainly I'd expect the 'break even' length will be much higher.

	David