[PATCH net-next 9/9] bnx2x: Change duplex setting in EEE function
From: Yaniv Rosner <hidden>
Date: 2012-11-27 11:47:32
Subsystem:
broadcom bnx2x 10 gigabit ethernet driver, networking drivers, the rest · Maintainers:
Sudarsana Kalluru, Manish Chopra, Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Linus Torvalds
This is not a real problem, since the EEE is supported for devices where the actual_phy_selection is zero, such that the req_duplex of params will match the one of the phy struct. Signed-off-by: Yaniv Rosner <redacted> Signed-off-by: Eilon Greenstein <redacted> --- drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c | 4 ++-- 1 files changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c
index ebab35d..3e7d824 100644
--- a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c
+++ b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c@@ -10119,7 +10119,7 @@ static int bnx2x_848x3_config_init(struct bnx2x_phy *phy, return rc; } - if ((params->req_duplex[actual_phy_selection] == DUPLEX_FULL) && + if ((phy->req_duplex == DUPLEX_FULL) && (params->eee_mode & EEE_MODE_ADV_LPI) && (bnx2x_eee_calc_timer(params) || !(params->eee_mode & EEE_MODE_ENABLE_LPI)))
@@ -13451,7 +13451,7 @@ static void bnx2x_check_kr2_wa(struct link_params *params, if (!(vars->link_attr_sync & LINK_ATTR_SYNC_KR2_ENABLE)) { if (!not_kr2_device) { DP(NETIF_MSG_LINK, "BP=0x%x, NP=0x%x\n", base_page, - next_page); + next_page); bnx2x_kr2_recovery(params, vars, phy); } return;
--
1.7.1