[PATCH 3/5] net/mlx4_en: Call netif_carrier_off() after register_netdev()

For carrier detection to work properly when binding the driver with a
cable unplugged, netif_carrier_off() should be called after
register_netdev(), not before.

Calling netif_carrier_off() before register_netdev() was causing the
network interface to miss a linkwatch pending event leading to an
inconsistent state if the link is not up when interface is initialized.

Found by Linux Driver Verification project (linuxtesting.org).

Signed-off-by: Ilya Shchepetkov <redacted>
---
 drivers/net/ethernet/mellanox/mlx4/en_netdev.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/drivers/net/ethernet/mellanox/mlx4/en_netdev.c b/drivers/net/ethernet/mellanox/mlx4/en_netdev.c
index edd9cb8..7bf2923 100644
--- a/drivers/net/ethernet/mellanox/mlx4/en_netdev.c
+++ b/drivers/net/ethernet/mellanox/mlx4/en_netdev.c

@@ -1676,13 +1676,13 @@ int mlx4_en_init_netdev(struct mlx4_en_dev *mdev, int port,
 
 	mdev->pndev[port] = dev;
 
-	netif_carrier_off(dev);
 	err = register_netdev(dev);
 	if (err) {
 		en_err(priv, "Netdev registration failed for port %d\n", port);
 		goto out;
 	}
 	priv->registered = 1;
+	netif_carrier_off(dev);
 
 	en_warn(priv, "Using %d TX rings\n", prof->tx_ring_num);
 	en_warn(priv, "Using %d RX rings\n", prof->rx_ring_num);

-- 
1.7.7