Thread (8 messages) 8 messages, 4 authors, 2012-07-09

[PATCH] net/macb: manage carrier state with call to netif_carrier_{on|off}()

From: Nicolas Ferre <hidden>
Date: 2012-07-04 09:14:13
Also in: linux-arm-kernel
Subsystem: atmel macb ethernet driver, networking drivers, the rest · Maintainers: Théo Lebrun, Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Linus Torvalds

OFF carrier state is setup in probe() open() and suspend() functions.
The carrier ON state is managed in macb_handle_link_change().

Signed-off-by: Nicolas Ferre <redacted>
---
Hi,

This patch follows the discussion about IPv6 and macb interface
("ADDRCONF(NETDEV_UP): eth0: link is not ready" with IPv6)
It may not address all aspects of the discussion, so please do comments...

I am still wondering if netif_carrier_off() is needed in macb_probe() *after*
the call to register_netdev() in addition to its inclusion in the open()
function. As I saw it in sevral drivers, I kept it.

I have tested several suspend/resume loops, and I think that just calling
netif_carrier_off() in suspend() function is sufficient: am I right?

Thanks for your help,
Best regards,

 drivers/net/ethernet/cadence/macb.c |   13 +++++++++++--
 1 file changed, 11 insertions(+), 2 deletions(-)
diff --git a/drivers/net/ethernet/cadence/macb.c b/drivers/net/ethernet/cadence/macb.c
index 1466bc4..033064b 100644
--- a/drivers/net/ethernet/cadence/macb.c
+++ b/drivers/net/ethernet/cadence/macb.c
@@ -179,13 +179,16 @@ static void macb_handle_link_change(struct net_device *dev)
 	spin_unlock_irqrestore(&bp->lock, flags);
 
 	if (status_change) {
-		if (phydev->link)
+		if (phydev->link) {
+			netif_carrier_on(dev);
 			netdev_info(dev, "link up (%d/%s)\n",
 				    phydev->speed,
 				    phydev->duplex == DUPLEX_FULL ?
 				    "Full" : "Half");
-		else
+		} else {
+			netif_carrier_off(dev);
 			netdev_info(dev, "link down\n");
+		}
 	}
 }
 
@@ -1033,6 +1036,9 @@ static int macb_open(struct net_device *dev)
 
 	netdev_dbg(bp->dev, "open\n");
 
+	/* carrier starts down */
+	netif_carrier_off(dev);
+
 	/* if the phy is not yet register, retry later*/
 	if (!bp->phy_dev)
 		return -EAGAIN;
@@ -1406,6 +1412,8 @@ static int __init macb_probe(struct platform_device *pdev)
 
 	platform_set_drvdata(pdev, dev);
 
+	netif_carrier_off(dev);
+
 	netdev_info(dev, "Cadence %s at 0x%08lx irq %d (%pM)\n",
 		    macb_is_gem(bp) ? "GEM" : "MACB", dev->base_addr,
 		    dev->irq, dev->dev_addr);
@@ -1469,6 +1477,7 @@ static int macb_suspend(struct platform_device *pdev, pm_message_t state)
 	struct net_device *netdev = platform_get_drvdata(pdev);
 	struct macb *bp = netdev_priv(netdev);
 
+	netif_carrier_off(netdev);
 	netif_device_detach(netdev);
 
 	clk_disable(bp->hclk);
-- 
1.7.10
Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help