[PATCH] gianfar: Fix RXICr/TXICr programming for multi-queue mode
From: Claudiu Manoil <hidden>
Date: 2012-06-28 14:42:29
Subsystem:
freescale etsec ethernet driver (gianfar), networking drivers, the rest · Maintainers:
Claudiu Manoil, Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Linus Torvalds
The correct behavior is to program the interrupt coalescing regs (RXICr/TXICr) in accordance with the Rx/Tx Q's "rx/txcoalescing" flag. That is, if the coalescing flag is 0 for a given Rx/Tx queue then the corresponding coalescing register should be cleared. This behavior is correctly implemented for the single-queue mode (SQ_SG_MODE), but not for the multi-queue mode (MQ_MG_MODE). This fixes the later case. Signed-off-by: Claudiu Manoil <redacted> --- drivers/net/ethernet/freescale/gianfar.c | 10 ++++------ 1 files changed, 4 insertions(+), 6 deletions(-)
diff --git a/drivers/net/ethernet/freescale/gianfar.c b/drivers/net/ethernet/freescale/gianfar.c
index f00a095..af16f9f 100644
--- a/drivers/net/ethernet/freescale/gianfar.c
+++ b/drivers/net/ethernet/freescale/gianfar.c@@ -1815,18 +1815,16 @@ void gfar_configure_coalescing(struct gfar_private *priv, if (priv->mode == MQ_MG_MODE) { baddr = ®s->txic0; for_each_set_bit(i, &tx_mask, priv->num_tx_queues) { - if (likely(priv->tx_queue[i]->txcoalescing)) { - gfar_write(baddr + i, 0); + gfar_write(baddr + i, 0); + if (likely(priv->tx_queue[i]->txcoalescing)) gfar_write(baddr + i, priv->tx_queue[i]->txic); - } } baddr = ®s->rxic0; for_each_set_bit(i, &rx_mask, priv->num_rx_queues) { - if (likely(priv->rx_queue[i]->rxcoalescing)) { - gfar_write(baddr + i, 0); + gfar_write(baddr + i, 0); + if (likely(priv->rx_queue[i]->rxcoalescing)) gfar_write(baddr + i, priv->rx_queue[i]->rxic); - } } } }
--
1.6.6