Re: [PATCH 03/10] stmmac: sanitize the rx coe and add the type-1 csum

On 3/24/2012 10:21 AM, Deepak SIKRI wrote:

On 3/23/2012 2:38 PM, Giuseppe CAVALLARO wrote:

quoted

[snip]


-    priv->rx_coe = priv->hw->mac->rx_coe(priv->ioaddr);
-    if (priv->rx_coe)
-        pr_info(" RX Checksum Offload Engine supported\n");
+    if (priv->plat->rx_coe)
+        pr_info(" RX Checksum Offload Engine supported (type %d)\n",
+            priv->plat->rx_coe);
      if (priv->plat->tx_coe)
          pr_info(" TX Checksum insertion supported\n");

rx_coe needs to be enabled. Earlier it was being done. Any specific
reasons to remove this.
Instead this code needs to be moved post mac reset has been done.

Hello Deepak

sorry for this delay.

I've not clear at all your question.
The driver well uses the rx_coe as briefly described below:

probe funct
  |__ hw_init
         |_ check the RX type from HW cap reg
                 |__ Override the rx_coe if required

After that the rx_coe is used and passed to the core as expected.
In case of there is no HW cap register so the rx_coe from platform will
be used.

Peppe

Regards
Deepak