[PATCH 1/1] net/macb: add DT support

@@ -0,0 +1,22 @@
+* Cadence EMACB
+
+Implemeted on Atmel AT91 & AVR32 SoC
+
+Required properties:
+- compatible : Should be "atmel,macb" for Atmel
+- reg : Address and length of the register set for the device
+- interrupts : Should contain macb interrupt
+- phy-mode : String, operation mode of the PHY interface.
+  Supported values are: "mii", "rmii",
+
+Optional properties:
+- local-mac-address : 6 bytes, mac address
+
+Examples:
+
+	macb0: macb@fffc4000 {
+		compatible = "atmel,macb";
+		reg = <oxfffc4000 0x4000>;
+		interrupts = <21>;
+		phy-mode = "mii";
+	};

@@ -20,6 +20,9 @@
 #include <linux/etherdevice.h>
 #include <linux/dma-mapping.h>
 #include <linux/platform_device.h>
+#include <linux/of.h>
+#include <linux/of_device.h>
+#include <linux/of_net.h>
 #include <linux/phy.h>
 
 #include <mach/board.h>

@@ -81,6 +84,20 @@ static void __init macb_get_hwaddr(struct macb *bp)
 	addr[4] = top & 0xff;
 	addr[5] = (top >> 8) & 0xff;
 
+#ifdef CONFIG_OF
+	/*
+	 * 2) from device tree data
+	 */
+	if (!is_valid_ether_addr(addr)) {
+		struct device_node *np = bp->pdev->dev.of_node;
+		if (np) {
+			const char *mac = of_get_mac_address(np);
+			if (mac)
+				memcpy(addr, mac, sizeof(addr));
+		}
+	}
+#endif
+
 	if (is_valid_ether_addr(addr)) {
 		memcpy(bp->dev->dev_addr, addr, sizeof(addr));
 	} else {

@@ -191,7 +208,6 @@ static int macb_mii_probe(struct net_device *dev)
 {
 	struct macb *bp = netdev_priv(dev);
 	struct phy_device *phydev;
-	struct eth_platform_data *pdata;
 	int ret;
 
 	phydev = phy_find_first(bp->mii_bus);

@@ -200,14 +216,11 @@ static int macb_mii_probe(struct net_device *dev)
 		return -1;
 	}
 
-	pdata = bp->pdev->dev.platform_data;
 	/* TODO : add pin_irq */
 
 	/* attach the mac to the phy */
 	ret = phy_connect_direct(dev, phydev, &macb_handle_link_change, 0,
-				 pdata && pdata->is_rmii ?
-				 PHY_INTERFACE_MODE_RMII :
-				 PHY_INTERFACE_MODE_MII);
+				 bp->phy_interface);
 	if (ret) {
 		printk(KERN_ERR "%s: Could not attach to PHY\n", dev->name);
 		return ret;

@@ -1117,6 +1130,30 @@ static const struct net_device_ops macb_netdev_ops = {
 #endif
 };
 
+#if defined(CONFIG_OF)
+static const struct of_device_id macb_dt_ids[] = {
+	{ .compatible = "atmel,macb" },
+	{ /* sentinel */ }
+};
+
+MODULE_DEVICE_TABLE(of, macb_dt_ids);
+
+static int __devinit macb_get_phy_mode_dt(struct platform_device *pdev)
+{
+	struct device_node *np = pdev->dev.of_node;
+
+	if (np)
+		return of_get_phy_mode(np);
+
+	return -ENODEV;
+}
+#else
+static int __devinit macb_get_phy_mode_dt(struct platform_device *pdev)
+{
+	return -ENODEV;
+}
+#endif
+
 static int __init macb_probe(struct platform_device *pdev)
 {
 	struct eth_platform_data *pdata;

@@ -1210,20 +1247,31 @@ static int __init macb_probe(struct platform_device *pdev)
 	macb_writel(bp, NCFGR, config);
 
 	macb_get_hwaddr(bp);
-	pdata = pdev->dev.platform_data;
 
-	if (pdata && pdata->is_rmii)
+	err = macb_get_phy_mode_dt(pdev);
+	if (err < 0) {
+		pdata = pdev->dev.platform_data;
+		if (pdata && pdata->is_rmii)
+			bp->phy_interface = PHY_INTERFACE_MODE_RMII;
+		else
+			bp->phy_interface = PHY_INTERFACE_MODE_MII;
+	} else {
+		bp->phy_interface = err;
+	}
+
+	if (bp->phy_interface == PHY_INTERFACE_MODE_RMII) {
 #if defined(CONFIG_ARCH_AT91)
 		macb_writel(bp, USRIO, (MACB_BIT(RMII) | MACB_BIT(CLKEN)) );
 #else
 		macb_writel(bp, USRIO, 0);
 #endif
-	else
+	} else {
 #if defined(CONFIG_ARCH_AT91)
 		macb_writel(bp, USRIO, MACB_BIT(CLKEN));
 #else
 		macb_writel(bp, USRIO, MACB_BIT(MII));
 #endif
+	}
 
 	bp->tx_pending = DEF_TX_RING_PENDING;
 

@@ -1344,6 +1392,7 @@ static struct platform_driver macb_driver = {
 	.driver		= {
 		.name		= "macb",
 		.owner	= THIS_MODULE,
+		.of_match_table	= of_match_ptr(macb_dt_ids),
 	},
 };
 

@@ -389,6 +389,8 @@ struct macb {
 	unsigned int 		link;
 	unsigned int 		speed;
 	unsigned int 		duplex;
+
+	phy_interface_t		phy_interface;
 };
 
 #endif /* _MACB_H */