[PATCH net-next v2 3/8] ibmveth: disable the reset work before unregister in remove

ibmveth_remove() cancels the reset work before unregister_netdev(),
but NAPI keeps running until unregister closes the device and can
queue the reset again, on an interrupt enable failure, a bad
free_map entry or a bad RX slot. The reset can then run on the
adapter after free_netdev(), or reopen the device during unregister.

Use disable_work_sync(), which waits for a running reset and keeps
the work from being queued again. A bad RX slot also makes poll
spin, which can stall unregister; a later patch in this series
fixes that.

Found by AI-assisted review of the ibmveth multi-queue RX series and
confirmed by code inspection; it was not reproduced. Tested on a POWER10
LPAR with unbind and bind cycles under traffic. No kernel selftests
cover ibmveth.

Fixes: 2c91e2319ed9 ("net: ibmveth: Reset the adapter when unexpected states are detected")
Signed-off-by: Mingming Cao <redacted>
---
 drivers/net/ethernet/ibm/ibmveth.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/net/ethernet/ibm/ibmveth.c b/drivers/net/ethernet/ibm/ibmveth.c
index dab571fe8dde..d269599f5a99 100644
--- a/drivers/net/ethernet/ibm/ibmveth.c
+++ b/drivers/net/ethernet/ibm/ibmveth.c

@@ -1954,7 +1954,7 @@ static void ibmveth_remove(struct vio_dev *dev)
 	struct ibmveth_adapter *adapter = netdev_priv(netdev);
 	int i;
 
-	cancel_work_sync(&adapter->work);
+	disable_work_sync(&adapter->work);
 
 	for (i = 0; i < IBMVETH_NUM_BUFF_POOLS; i++)
 		kobject_put(&adapter->rx_buff_pool[i].kobj);

-- 
2.39.3 (Apple Git-146)