Hello Kenji-san,

Kenji Kaneshige wrote:

Felix Radensky wrote:

quoted

Hello Kenji-san,

Kenji Kaneshige wrote:

quoted

I'm not sure, but I guess pci_setup_bridge() didn't update IO 
base/limit
and Mem base/limit of the bridge (0000:00:02.0) because of the 
following
lines.

static void pci_setup_bridge(struct pci_bus *bus)
{
       struct pci_dev *bridge = bus->self;
       struct resource *res;
       struct pci_bus_region region;
       u32 l, bu, lu, io_upper16;

       if (pci_is_enabled(bridge))    
<===============================                              
return;            <===============================

       dev_info(&bridge->dev, "PCI bridge to [bus %02x-%02x]\n",
                bus->secondary, bus->subordinate);
    ...

It seems the bridge was already enabled by 
pci_assign_unassigned_resources()
at boot time. Does removing those lines make any change?

Yes, with these lines removed bridge memory window is properly 
allocated.

These lines are to prevent updating IO or memory windows when there are
some devices working behind the bridge. So please note that removing
these lines is just for debugging.

quoted

For some reason bridge memory is disabled, but if I enable it via 
setpci, and
also enable device memory, then everything works fine. If the system 
is booted
when device behind the bridge is plugged in, bridge memory is enabled.

Maybe because of the following lines, I guess.

void pci_enable_bridges(struct pci_bus *bus)
{
       struct pci_dev *dev;
       int retval;

       list_for_each_entry(dev, &bus->devices, bus_list) {
               if (dev->subordinate) {
                       if (!pci_is_enabled(dev)) {        <=======
                               retval = pci_enable_device(dev);<=======
                               pci_set_master(dev);        <=======
                       }
        ...

Yes, but removing this check is not enough. The bridge is enabled after 
first scan, but it's
memory is disabled. So simply calling  pci_enable_device() will not 
help, it will return without
enabling memory. I had to call  pci_disable_device() before 
pci_enable_device() to make things
work.

One possible cause is that pcibios_enable_device() for the bridge didn't
return any error even though it didn't work properly (ex. cannot access
to the command register, and so on) on your platform when there is no
device behind the bridge. But it is just my guess.

Should pcibios_enable_device() return an error if it fails to enable 
bridge memory ?

Thanks.

Felix.