Re: 8272ADS and Linux 2.6.12

Here's my serial config..., also these dont show up if i just=20
run "make ads8272_defconfig". I have to explicitly go and enable the
serial options.


#
# Serial drivers
#
CONFIG_SERIAL_8250=3Dy
CONFIG_SERIAL_8250_CONSOLE=3Dy
CONFIG_SERIAL_8250_NR_UARTS=3D4
# CONFIG_SERIAL_8250_EXTENDED is not set

#
# Non-8250 serial port support
#
CONFIG_SERIAL_CORE=3Dy
CONFIG_SERIAL_CORE_CONSOLE=3Dy
# CONFIG_SERIAL_CPM is not set
# CONFIG_SERIAL_JSM is not set
CONFIG_UNIX98_PTYS=3Dy
CONFIG_LEGACY_PTYS=3Dy
CONFIG_LEGACY_PTY_COUNT=3D256

Thanks!
ashutosh

On 7/14/05, Allen Curtis [off-list ref] wrote:

quoted

=3D> setenv bootargs console=3DttyCPM0,115200  root=3D/dev/ram
=3D> bootm fe600000
## Booting image at fe600000 ...
   Image Name:   2.6.12 for 8272
   Image Type:   PowerPC Linux Kernel Image (gzip compressed)
   Data Size:    875845 Bytes =3D 855.3 kB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK

=20
Can you provide your kernel configuration information regarding the
serial ports. Which serial port is your console port? Check the
following configuration options:
  CONFIG_SERIAL_CONSOLE
  CONFIG_SCC_CONSOLE
  CONFIG_SERIAL_CORE
  CONFIG_SERIAL_CORE_CONSOLE
=20
Another observation is that you are trying to boot with a RAM disk but
you have not provided the RAM disk address to the bootm command. This
is not your current problem since you don't get that far.
=20
- Allen
=20