Re: How to remove JFFS2 'Making dirty' display on RPXlite DW?

When creating a JFFS2 filesytem with DENX SELF ramdisk
as follows,the target displayed some wired
message,what would be problem be?

=====================================================

After unpacking SELF,I use the following command to
create a jffs2 filesystem:

eraseall /dev/mtd3

mkfs.jffs2 -r /tmp/tmp -e 0x10000 -o image.jffs2 -b

dd if=image.jffs2 of=/dev/mtd3 bs=256k

mount -t jffs2 /dev/mtdblock3 /mnt

====================================================

What is the block size you specified when you do a mkfs.jffs2?

It has to match with your flash erase block size.  Care should be taken if
you have paralle banks.

I'm not sure this is your problem but it is a problem I ran into.

David

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/