Re: Lite5200 PCI not working

In message [ref] Stefan Nickl wrote:

On Mon, 2004-06-21 at 18:20, Kate Alhola wrote:

quoted

quoted

Are you really sure? Maybe it was just an issue of finding the  right
jumper  settings (which is non-trivial). We tested both with Rev. 4.0
and Rev. 5.0 cards, and didn't need -12V.

...

seems I'm also stuck with this non-trivial problem here.
I have a Rev.5 card, and just discovered the three jumpers
to override the analog MUX (J250-252).

I get a picture now, but it's *very* dim, and the colors
seem not quite right when the CRT's brightness is .

Are there any more jumpers to set or could this be an
issue with the driver (linuxppc_2_4_devel -Dyesterday)?
Or maybe is the MUXer also a neccessary booster?

I've updated the table to include  the  settings  for  the  Rev.  4.0
board, too, and to list ALL jumpers on the board.

OK. Please see http://www.denx.de/twiki/bin/view/DULG/CoralPInstallation

Hope this helps.

Best regards,

Wolfgang Denk

--
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd@denx.de
America has been discovered before, but it has always been hushed up.
- Oscar Wilde

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/