Re: Ebony Board, PPC440GP and NFS time out
From: Eugene Surovegin <hidden>
Date: 2004-05-19 23:42:28
On Wed, May 19, 2004 at 03:19:54PM -0700, Brian Hawley wrote:
Loading file "/zImage.ebony" ... Sending tftp boot request ... Transfer Complete ... Loaded successfully ... Entry point at 0x500000 ... loaded at: 00500000 005C81DC relocated to: 01000000 010C81DC zimage at: 01005847 010C4136 avail ram: 00400000 00800000 Linux/PPC load: ip=on Uncompressing Linux...done. Now booting the kernel Linux version 2.6.5 (bnh-engr@feimer) (gcc version 3.3.3) #1 Wed May 19 15:41:31 PDT 2004 IBM Ebony port (MontaVista Software, Inc. (source@mvista.com)) On node 0 totalpages: 32768 DMA zone: 32768 pages, LIFO batch:8 Normal zone: 0 pages, LIFO batch:1 HighMem zone: 0 pages, LIFO batch:1 Built 1 zonelists Kernel command line: ip=on PID hash table entries: 1024 (order 10: 8192 bytes) Memory: 127584k available (1212k kernel code, 428k data, 84k init, 0k highmem) Calibrating delay loop... 598.01 BogoMIPS Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) Mount-cache hash table entries: 512 (order: 0, 4096 bytes) POSIX conformance testing by UNIFIX NET: Registered protocol family 16 PCI: Probing PCI hardware Serial: 8250/16550 driver $Revision: 1.90 $ 6 ports, IRQ sharing enabled ttyS0 at MMIO 0x0 (irq = 0) is a 16550A ttyS1 at MMIO 0x0 (irq = 1) is a 16550A mal0: Initialized, 4 tx channels, 2 rx channels emac: IBM EMAC Ethernet driver, version 2.0 Maintained by Benjamin Herrenschmidt [off-list ref] zmii0: input 0 in SMII mode eth0: IBM emac, MAC 00:04:ac:e3:23:b2 eth0: Found Generic MII PHY (0x08) zmii0: input 1 in RMII mode eth1: IBM emac, MAC 00:04:ac:e3:23:b3 eth1: Found Generic MII PHY (0x09) mice: PS/2 mouse device common for all mice NET: Registered protocol family 2 IP: routing cache hash table of 1024 buckets, 8Kbytes TCP: Hash tables configured (established 8192 bind 16384) NET: Registered protocol family 1 NET: Registered protocol family 17 eth0: Link is Up eth0: Speed: 100, Full duplex. Sending BOOTP requests ...... timed out! IP-Config: Retrying forever (NFS root)... eth0: Speed: 100, Full duplex. Sending BOOTP requests ...
Looks fine until BOOTP stage. Use any sniffer to check whether BOOTP requests are coming out. Please, check that your DHCP server allows BOOTP clients. Eugene. ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/