Re: G4 + Linux + PCI device + x86 driver = 0

On Sat, 13 Nov 1999, David W. Patmore wrote:

[...]

The original x86 (Redhat 6.0) driver uses virt_to_bus() to get the address
to write to.  In LinuxPPC, that function is not available (not in name
table).  I guess that I'm supposed to use ioremap(), but that doesn't seem
to do it for me either.

Code snip:
	ul_reg_addr = p_dev->base_address[0];

	pul_remapped =ioremap( ul_reg_addr, 32 );

	printk( "pcidrv: base addr %08X \n", ul_reg_addr );
	printk( "pcidrv: pul_remapped %08X \n", pul_remapped );
	printk( "pcidrv: remapped data: %08X \n", *pul_remapped );

	iounmap( pul_remapped );

The outcome of running this code is:  pci base address (0x80890000),
remapped (0xC8271000), data (0xFFFFFFFF).  The data is a status word which I
expect to be not
all "F"s.  Note that iounmap is "TBD" in the source, so each time the code

Most likely, you need to enable I/O or/and memory access by hand.  OF
probably didn't enable it automatically.  For example,

	(void) pci_read_config_word(p_dev, PCI_COMMAND, &command);
	if (!(command & PCI_COMMAND_IO)) {
		command |= PCI_COMMAND_IO;
		(void) pci_write_config_word(p_dev, PCI_COMMAND, command);
		(void) pci_read_config_word(p_dev, PCI_COMMAND, &command);
		if (!(command & PCI_COMMAND_IO)) {
			printk(KERN_DEBUG "IO access enable failed\n");
			return 0;
		}
	}
	if (!(command & PCI_COMMAND_MEMORY)) {
		command |= PCI_COMMAND_MEMORY;
		(void) pci_write_config_word(p_dev, PCI_COMMAND, command);
		(void) pci_read_config_word(p_dev, PCI_COMMAND, &command);
		if (!(command & PCI_COMMAND_MEMORY)) {
			printk(KERN_DEBUG "Memory access enable failed\n");
			return 0;
		}
	}

This would make *pul_remapped return something different, I'd think.  See
other ppc drivers for more details.  You may need additional PCI fixups.


Takashi Oe


** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/