Re: loading firmware while usermodehelper disabled.

On Fri, Dec 30, 2011 at 04:22:06PM -0800, Linus Torvalds wrote:

It's isight_firmware_load(), in the isight_firmware driver. The driver
doesn't actually do anything but load the firmware, and is apparently
not very good at that either.

It should either fake a disconnect and reconnect of the device (and
let the reconnect then load the firmware through udev or something) or
it should just save the firmware image in memory from the original
load, and make the resume just re-initialize it - not load it.

Mm. My recollection is that these devices retained their firmware over 
suspend/resume, so wouldn't resume with a USB id that matched the driver 
and so this code shouldn't be called. It seems that either I was 
horribly wrong about that, or something's changed in the USB layer 
that's resulting in them resetting themselves. Newer devices don't 
require this, so I'll need to try to chase up some older hardware to 
figure out what's going on.

-- 
Matthew Garrett | mjg59@srcf.ucam.org