RE: Fwd: Linux Kernel 5.12.10 Walkman USB DAC support issues

On Tue, 27 Jul, 2021 at 1:02 pm, "Schmid, Carsten" 
[off-list ref] wrote:

Hi Neil,

quoted

 -----Original Message-----
 From: AMoonRabbit [off-list ref]

No top posts please.

On Tue, 27 Jul, 2021 at 7:43 am, "Schmid, Carsten"
[off-list ref] wrote:

quoted

 Hi Greg,

 On Tue, Jul 27, 2021 at 12:37:28AM +0100, Razgriz375 (Neil) wrote:

quoted

quoted

  [  109.668465] usb 1-1: USB disconnect, device number 2
  [  110.084429] usb 1-1: new high-speed USB device number 5 using
 xhci_hcd
  [  110.237963] usb 1-1: New USB device found, idVendor=054c,
 idProduct=0b8c, bcdDevice= 1.00
  [  110.237989] usb 1-1: New USB device strings: Mfr=2, Product=3,
 SerialNumber=4
  [  110.238002] usb 1-1: Product: WALKMAN
  [  110.238011] usb 1-1: Manufacturer: Sony
  [  110.238019] usb 1-1: SerialNumber: 10458B55477916
  [  110.342104] usb 1-1: 1:7 : unsupported format bits 0x100000000
  [  110.343953] usbcore: registered new interface driver
 snd-usb-audio

  Looks like you removed the device and then added it back?  And it
 says
  the device is supported by the kernel now, what does not work
 properly?

 But earlier in boot these messages are seen:
 [    1.908489] usb 1-1: New USB device found, idVendor=054c,
 idProduct=0ca1, bcdDevice= 1.00
 [    1.908503] usb 1-1: New USB device strings: Mfr=2, Product=3,
 SerialNumber=4
 [    1.908508] usb 1-1: Product: WALKMAN
 [    1.908513] usb 1-1: Manufacturer: Sony
 [    1.908516] usb 1-1: SerialNumber: 10458B55477916
 [    2.195821] usb-storage 1-1:1.0: USB Mass Storage device detected
 [    2.195988] scsi host0: usb-storage 1-1:1.0

 ProductId is different, that's strange.

 Neil, could you collect the dmesg from the working kernel 5.10 
please?
 And: is the device expected to be a mass storage (aka USB disk) and
 sound card in one?

Responded to this already in the email on the 27th July.

quoted

 So this is the Dmesg output from 5.10.17 with working output to USB 
DAC
 (Walkman visually gets audio as the amp meter visualiser works 
where as
 on newer kernels, whilst the system looks to be outputting sound, 
the
 Walkman shows it's receiving nothing).

...

quoted

 [   12.202312]usb 1-1: new high-speed USB device number 3 using 
xhci_hcd
 [   12.351838]usb 1-1: New USB device found, idVendor=054c,
 idProduct=0b8c, bcdDevice= 1.00
 [   12.351844]usb 1-1: New USB device strings: Mfr=2, Product=3,
 SerialNumber=4
 [   12.351847]usb 1-1: Product: WALKMAN
 [   12.351850]usb 1-1: Manufacturer: Sony
 [   12.351852]usb 1-1: SerialNumber: 10458B55477916
 [   38.560172]usb 1-1: 1:7 : unsupported format bits 0x100000000
 [   38.562750]usbcore: registered new interface driver snd-usb-audio
 [   38.630995]snd_hda_intel 0000:00:1f.3: DSP detected with PCI
 class/subclass/prog-if info 0x040380

Looks like on the old kernel the Walkman is seen as the first sound 
card.
On the new kernel, it was seen as a mass storage first and later 
switched to snd-usb.
Please check if your Walkman appears as a sound card in the new kernel
and if it is muted due to not being the default output.

So I have checked this, starting with the Walkman connected in DAC 
mode, so it is only seen in DAC mode. Pop OS updates the sound settings 
so that the Walkman is the selected output device. It does not show as 
muted. Within ALSA Mixer, I see that HDA Intel PCM is first, and then 
the WALKMAN device, however when selecting WALKMAN I get "This sound 
device does not have any controls".

Thanks,
Carsten
-----------------
Siemens Electronic Design Automation GmbH; Anschrift: Arnulfstraße 
201, 80634 München; Gesellschaft mit beschränkter Haftung; 
Geschäftsführer: Thomas Heurung, Frank Thürauf; Sitz der 
Gesellschaft: München; Registergericht München, HRB 106955

Kind regards,

Neil