On Sun, Dec 12, 2021 at 12:13:59AM +0300, Dmitry Osipenko wrote:

From: Stefan Eichenberger <redacted>

If an USB port is an OTG port, then we should add the usb-role-switch
property. Otherwise XUSB setup fails and therefore padctl is unable to
set up the ports. This leads to broken USB and PCIe ports. Add the
usb-role-switch properties to Tegra124 device-trees to fix the problem.

The error message shown without this patch is e.g:
usb2-0: usb-role-switch not found for otg mode

[digetx@gmail.com: improved commit message]
Tested-by: Thomas Graichen <redacted> # T124 Nyan Big
Signed-off-by: Stefan Eichenberger <redacted>
Signed-off-by: Dmitry Osipenko <digetx@gmail.com>
---
 arch/arm/boot/dts/tegra124-apalis-v1.2.dtsi | 1 +
 arch/arm/boot/dts/tegra124-apalis.dtsi      | 1 +
 arch/arm/boot/dts/tegra124-nyan.dtsi        | 1 +
 arch/arm/boot/dts/tegra124-venice2.dts      | 2 +-
 4 files changed, 4 insertions(+), 1 deletion(-)

The device tree bindings for the XUSB pad controller say that when this
property is set, then the "connector" subnode should also exist.

Any chance we can add that? I was planning on making that a dependency
in the json-schema conversion of the binding, in which case it would be
more of a "must" than a "should".

Thierry