Hi Neil/Martin,

I have pulled the latest git version (up and including Makefile: check 
that 'run' directory exists.).
It works, except for the last error I noticed, see below.

Regards,

Albert


On 08/04/2013 11:47 AM, Albert Pauw wrote:

Hi Martin,

I noticed another problem, with or without your patch, the problem 
occurs:

Zeroed the superblocks (just in case):
mdadm --zero-superblock /dev/loop[1-6]

Created the container:
mdadm -CR /dev/md127 -e ddf -l container -n 5 /dev/loop[1-5]

Created an md device in the container, it used /dev/loop4 and 
/dev/loop5, rebuild and finished
mdadm -CR /dev/md0 -l raid1 -n 2 /dev/md127

I fail one of the disks, it rebuild with one of the available unused 
disks in the container:
mdadm -f /dev/md0 /dev/loop4

I add another md device.
mdadm -CR /dev/md1 -l raid5 -n 3 /dev/md127

This last one is the odd bit, it is build using the previously failed 
disk. Looks like the container is not aware that /dev/loop4 has failed,
en reuses it. Which is wrong. So the failed status is not kept.

Regards,

Albert