Re: rebuild raid6 after two failures

From
Keith Keller <hidden>
Date
2012-02-01 04:42:28
Reply to
Keith Keller, 2012-01-31
On 2012-01-31, Keith Keller [off-list ref] wrote:
I recently had a RAID6 lose two drives in quick succession, with one
spare already in place.  The rebuild started fine with the spare, but
now that I've replaced the failed disks, should I expect the current
rebuild to finish, then rebuild on another spare?
[snip]

Well, for better or worse, this is now a moot question--I had another
drive kicked out of the array, I believe prematurely by the controller.
I was able to --assemble --force the array, and it is now rebuilding
two spares instead of one.  AFAIR there was no activity on the
filesystem at the time, so I am optimistic that the filesystem should be
fine after an fsck.  Thanks to the advice from last time which suggested
--assemble --force instead of --assume-clean in this situation.

Could it have been the older version of mdadm that didn't tell the
kernel to start rebuilding the added spare?  I have made 3.2.3 my
default mdadm, which I hope alleviates some of the issues I've had with
rebuilds not starting.  (As an aside, I've also bitten the bullet and
decided to swap out all the WD-EARS drives for real RAID drives; ideally
I'd replace the controller, but I don't want to invest the time needed
to replace and test all the components properly.)

--keith


-- 
kkeller@wombat.san-francisco.ca.us

Thread (9 messages) 9 messages, 4 authors, last reply 2012-02-07
Keyboard shortcuts
hback out one level
jnext message in thread / next series-diff position
kprevious message in thread / previous series-diff position
ldrill in
Escclose help / fold thread tree
?toggle this help