On Friday 16 March 2007 09:29, Benjamin Herrenschmidt wrote:
quoted
+ /*
+ * Map registers
+ */
+ i2o_reg = (i2o_regs_t *)ioremap64(I2O_MMAP_BASE, I2O_MMAP_SIZE);
+ dma_reg0 = (dma_regs_t *)ioremap64(DMA0_MMAP_BASE, DMA_MMAP_SIZE);
+ dma_reg1 = (dma_regs_t *)ioremap64(DMA1_MMAP_BASE, DMA_MMAP_SIZE);
+ xor_reg = (xor_regs_t *)ioremap64(XOR_MMAP_BASE,XOR_MMAP_SIZE);
You should test the result of these. Also, the move to arch/powerpc here
as well will cleanup as ioremap will always take 64 bits resource_size_t
(can't you make that working on arch/ppc too and use normal ioremap
there as well ?).
It's quite easy: Just configure CONFIG_RESOURCES_64BIT and you can use
the "normal" ioremap(). Wolfgang, please give it a try. It already works on
the Katmai and Taishan.
quoted
+ /*
+ * Configure h/w
+ */
+
+ /* Reset I2O/DMA */
+ mtdcr(DCRN_SDR0_CFGADDR, 0x200);
+ mtdcr(DCRN_SDR0_CFGDATA, 0x10000);
+ mtdcr(DCRN_SDR0_CFGADDR, 0x200);
+ mtdcr(DCRN_SDR0_CFGDATA, 0x0);
The above could use some symbolic constants... Is this the only piece of
code to access the SDR0 indirect config registers ? If not, then some
global locking is needed as well.
Please add
#define DCRN_SDR0_SRST0 0x200
#define SDR0_SRST_I2ODMA (0x80000000 > 15)
to include/asm-ppc/ppc44x.h
and then use
SDR_WRITE(DCRN_SDR0_SRST0, SDR0_SRST_I2ODMA);
SDR_WRITE(DCRN_SDR0_SRST0, 0);
here.
Best regards,
Stefan
=====================================================================
DENX Software Engineering GmbH, HRB 165235 Munich, CEO: Wolfgang Denk
Office: Kirchenstr. 5, D-82194 Groebenzell, Germany
=====================================================================