Re: future hardware

From
Rob Bray <hidden>
Date
2006-10-31 16:11:06
Reply to
Dan, 2006-10-21
I have been using an older 64bit system, socket 754 for a while now.  It
has
the old PCI bus 33Mhz.  I have two low cost (no HW RAID) PCI SATA I cards
each with 4 ports to give me an eight disk RAID 6.  I also have a Gig NIC,
on the PCI bus.  I have Gig switches with clients connecting to it at Gig
speed.

As many know you get a peak transfer rate of 133 MB/s or 1064Mb/s from
that
PCI bus http://en.wikipedia.org/wiki/Peripheral_Component_Interconnect

The transfer rate is not bad across the network but my bottle neck it the
PCI bus.  I have been shopping around for new MB and PCI-express cards.  I
have been using mdadm for a long time and would like to stay with it.  I
am
having trouble finding an eight port PCI-express card that does not have
all
the fancy HW RAID which jacks up the cost.  I am now considering using a
MB
with eight SATA II slots onboard.  GIGABYTE GA-M59SLI-S5 Socket AM2 NVIDIA
nForce 590 SLI MCP ATX.

What are other users of mdadm using with the PCI-express cards, most cost
effective solution?
I agree that SATA drives on PCI-E cards are as much bang-for-buck as is
available right now. On the newer platforms, each PCI-E slot, the onboard
RAID controller(s), and the 32-bit PCI bus all have discrete paths to the
chip.

Play with the thing to see how many disks you can put on a controller
without a slowdown. Don't assume the controller isn't oversold on
bandwidth (I was only able to use three out of four CK804 ports on a
GA-K8NE without saturating it; two out of four slots on a PCI Sil3114).
Combining the bandwidth of the onboard RAID controller, two SATA slots,
and one PCI controller card, sustained reads reach 450MB/s (across 7
disks, RAID-0) with an $80 board, and three $20 controller cards.
Thread (9 messages) 9 messages, 7 authors, last reply 2006-10-31
Keyboard shortcuts
hback out one level
jnext message in thread / next series-diff position
kprevious message in thread / previous series-diff position
ldrill in
Escclose help / fold thread tree
?toggle this help