Hi Zhang

Can you check this email ?

Thank you for your help

quoted

quoted

	non thermal-zon
	  sensor command: OK
	  read from /sys/class/thermal/thermal_zone0 : OK

	thermal-zon
	  sensor command: NG
	  read from /sys/class/thermal/thermal_zone0 : OK

config THERMAL_HWMON
        bool
        prompt "Expose thermal sensors as hwmon device"
        depends on HWMON=y || HWMON=THERMAL
        default y

please check if the thermal subsystem is built in, while hwmon subsystem
is built as module.
you should either set CONFIG_HWMON=y, or set both CONFIG_HWMON and
CONFIG_THERMAL as module.

Thanks. but it seems our system has it.

I noticed that thermal_zone case uses of_parse_thermal_zones()
and it has this.

		/* No hwmon because there might be hwmon drivers registering */
		tzp->no_hwmon = true;

and on thermal_zone_device_register() check this for hwmon

struct thermal_zone_device *thermal_zone_device_register(xxxx)
{
	...
	if (!tz->tzp || !tz->tzp->no_hwmon) {
		result = thermal_add_hwmon_sysfs(tz);
		...
	}
	...
}

Does this mean "thermal_zone doesn't use lm-senser" ?

Best regards
---
Kuninori Morimoto