On 30 March 2016 at 16:07, Jun Li [off-list ref] wrote:

Hi

quoted

On 30 March 2016 at 10:54, Jun Li [off-list ref] wrote:

quoted

quoted

quoted

quoted

It is not for udc driver but for power users who want to negotiate
with USB subsystem.

Seems you don't want to guarantee charger type detection is done
before gadget connection(pullup DP), right?
I see you call usb_charger_detect_type() in each gadget usb state

changes.

I am not sure I get your point correctly, please correct me if I
misunderstand you.
We need to check the charger type at every event comes from the usb
gadget state changes or the extcon device state changes, which means
a new charger plugin or pullup.

According to usb charger spec, my understanding is you can't do real
charger detection procedure *after* gadget _connection_(pullup DP),
also I don't

Why can not? Charger detection is usually from PMIC.

Charger detection process will impact DP/DM line state, see usb charger
spec v1.2 for detail detection process, section 4.6.3 says:

"A PD is allowed to *disconnect* and repeat the charger detection process
multiple times while attached. The PD is required to wait for a time of at
least TCP_VDM_EN max between disconnecting and restarting the charger
detection process."

As Peter mentioned, the charger detection should happen between VBUS
detection and gadget pull up DP for first plug in case. So when&after
gadget connect (pullup DP), you should already know the charger type.

Make sense. In our company's solution, charger detection can be done
by hardware from PMIC at first, then it will not affect the DP/DM line
when gadget starts to enumeration. In the 'usb_charger_detect_type()',
it usually get the charger type from type registers has been done by
hardware from PMIC, which can not affect the DP/DM line.

Li Jun

quoted

quoted

think it's necessary to check charger type at every event from usb

gadget.

My meaning is not every event from usb gadget. When the usb gadget state
changes or the extcon device (maybe GPIO detection) state changes, which
means charger plugin or pullup, we need to check the charger type to set
current.

From your below code, you call usb_charger_notify_others() in
every state change.

I think it does not matter. In case the usb charger missed some gadget
state changes. Or I replace it with 'USB_STATE_CONFIGURED' state.
Thanks.

if (uchger->old_gadget_state != state) {
        uchger->old_gadget_state = state;

        if (state >= USB_STATE_ATTACHED)
                uchger_state = USB_CHARGER_PRESENT;
        else if (state == USB_STATE_NOTATTACHED)
                uchger_state = USB_CHARGER_REMOVE;
        else
/* this else will never happen */
                uchger_state = USB_CHARGER_DEFAULT;

        usb_charger_notify_others(uchger, uchger_state);
}

quoted

quoted

Something in gadget driver you can utilize is only vbus detection, and
report diff current by diff usb state if it's a SDP.

--
Baolin.wang
Best Regards

-- 
Baolin.wang
Best Regards