Hi Neil,

On Mon, Aug 30, 2021 at 9:45 AM Neil Armstrong [off-list ref] wrote:

Hi,

On 17/08/2021 06:15, Anand Moon wrote:

quoted

Add missing usb phy power node for usb node fix below warning.
P5V0 regulator supply input voltage range to USB host controller.
As described in the C1+ schematics, GPIO GPIOAO_5 is used to
enable input power to USB ports, set it to Active Low.

[    1.260772] dwc2 c90c0000.usb: Looking up vbus-supply from device tree
[    1.260784] dwc2 c90c0000.usb: Looking up vbus-supply property in
              mode /soc/usb@c90c0000 failed

First of all, DT is not here to fix boot message.

Anand mentioned elsewhere that this is a debug/info message

Finally, I looked at the Odroid-C1 schematics and the GPIOAO.BIT5 is an input
to the S805, and the PWREN signal is controlled by the USB Hub so this regulator
should not be added at all.

I think there's a misunderstanding because there's two PWREN signals
with different meanings.
The PWREN signal for the USB host ports is hard-wired and not
connected to the SoC at all.
The PWREN signal for the Micro-USB port (which Anand is adding here)
is controlled by GPIOAO_5. odroid-c1+_rev0.4_20150615.pdf [0] shows it
as an input to "USB_OTG" on page 1. "USB_OTG" consists of a power
switch and the connector itself as shown on page 28.

Personally I think that the change from Anand itself is good.
If you feel otherwise then please speak up.
As I pointed out three smaller changes I am hoping that Anand will
re-send the updated patch anyways. At that point he can also add the
changes from your feedback.


Best regards,
Martin


[0] https://dn.odroid.com/S805/Schematics/odroid-c1+_rev0.4_20150615.pdf

-- 
linux-phy mailing list
linux-phy@lists.infradead.org
https://lists.infradead.org/mailman/listinfo/linux-phy